1-1. CABINET REMOVAL
3
1-2. SERVICE POSITION
1
Gently wiggle the A board back and forth to unplug
it from the Neck Assembly.
2
Remove all necessary connections and rotate the
D Board and rest it on its side to expose the bottom.
Be sure to reconnect all wires.
3
Fabricate a temporary ground wire with a male
stakon connector on one end and an alligator clip
on the other.
4
Reconnect ground as shown below.
SECTION 1: DISASSEMBLY
2
4
1
Remove (2) screws (+BVTP 4 x 16).
2
Release side claw - Insert the tip of a flathead
5
screwdriver approximately 0.25" to unlock the
claw.
3
Release top claw - Working from the same
side as the claw in Step 2, insert the tip of a
flathead screwdriver to unlock the top claw.
4
Release top claw - Repeat Step 3 on the
opposite side.
5
Release side claw - Repeat Step 2 on the
opposite side and gently lift up and then back
to remove the cabinet.
1
1
— 7 —
2
4
HMD-A240R