Watching TV
Cable / Satellite / Fiber Optic box
Initial setting
1. Connecting
Select the wiring method connecting your box to the TV, AV IN or
Antenna/Cable in.
Note:
HDMI will provide the best HD picture
●
2. Change INPUT
INPUT
Press the
INPUT
3. Power on your Cable, Satellite or Fiber Optic box
Use the box's remote control to change channels.
If the box is connected to the TV using a COAX cable (Antenna/Cable
●
in), then set the TV channel to CH3 or CH4. Note that the picture will
not be in HD.
CC/SAP is not available when watching TV with a Cable or Satellite
●
box connected via HDMI.
If you have a High Definition box, ensure that it is outputting 720p or
●
1080i signal.
Tip: press the TV's
Check your box's "aspect" or "format" settings. It should be set to 16:9,
●
Widescreen or Full.
If the audio volume is too low, check the box's audio settings.
●
Contact your Cable or Satellite provider for instructions on any box
●
settings.
button to select the proper connection. Wait 2 seconds.
INFO
button to verify.
- 15 -