Noisy Stereo Reception - RCA guide plus User Manual

Reference
Can't select certain channel
• Channel may be blocked or not approved in the Parental Controls menu.
• If using a VCR, check to make sure the TV/VCR switch on the VCR is in the correct position.

Noisy stereo reception

• May be a weak station. Use SOUND button to change to mono mode instead of stereo.
No picture, no sound but TV is on
• Maybe the cable/air function is set to the wrong position.
• Maybe a vacant channel is tuned.
• If watching VCR (connected only through antenna input), make sure TV is tuned to channel 3 or 4 – same as CH3/4
switch on VCR. Also check to make sure TV/VCR switch on VCR is in the correct position.
Sound okay, picture poor
• Check antenna connections.
• Try adjusting sharpness function to improve weak signals.
Black Box appears on the screen
• Captioning may be turned on. Check the Closed-Caption Display control panel in the Channel menu.
GUIDE PIus+ IR Controllers not working
• Check to make sure the controllers are positioned correctly over the IR remote sensors.
• Your remote may be interfering with the IR controller. Place a piece of dark tape over the IR controller.
• GUIDE Plus+ control of cable box is slower than direct control of the box itself. Keep this in mind when changing
channels.
Incorrect GUIDE PIus+ Channel Map
• The guide may get out of sync with the cable provider. Use setup to change the zip code to 99999. Turn the TV off for
ten minutes. Use setup again to change zip code to the correct value. Be sure to select the correct lineup if asked.
55