Wiring Diagram - KitchenAid Pro Line Series Installation And Use Instructions Manual

• Carefully push the lamp out of its
socket clips.
• Insert new 20 watt halogen lamp into
socket and push into clips.
• Replace the lamp panel and retainer
clips. Tighten clip screws securely.
• Reconnect power.
Cleaning
Metal filters:
To remove filters:
Note: Use two hands to remove
filters, one to pull and turn the knob,
the other to hold the filter so that it
doesn't fall onto the cooktop.
• Pull knob forward, toward the
front of the hood, while turning
the knob to the left (counter-
clockwise) to release the locking
lever.
• Slide filter down and away from front
retaining channel.
• Wash metal filters as needed in
dishwasher or hot detergent solution
to clean.
To reinstall filters:
Note: Use two hands to install
filter, one to pull and turn the
knob, the other to hold the filter in
place so that it doesn't fall.
• Grasp one of the filters so that
the knob faces down and toward
the back of the hood.
• Insert the filter end without the
knob into the retaining channel in
the front of the hood.
• Pull knob forward, toward the front of
hood, while turning knob to the left
(counterclockwise) so that the locking
lever does not protrude from the
filter.
• Insert the knob end of the filter
into the retaining channel in the
back of the hood.
• Turn the knob to the right
(clockwise) to lock the filter in
place.
• Repeat for remaining filters.
Charcoal filters
(Used with
non-vented installations only)
Replace the charcoal filter every four
months or more often if needed. The
charcoal filter cannot be washed or
cleaned.
The charcoal filter is located behind
the middle metal filter and is attached
to the exhaust opening.
10
To remove charcoal filter:
• Remove the metal filters (see "Metal
filters" above).
• Rotate the two metal filter clips
toward the filter to release the
charcoal filter. Remove old filter.
• Insert new filter and pull clips down
(See Step 24).
• Reinstall metal filter (see "Metal
filters" above).
Exterior surfaces:
• Do not use steel wool or soap-
filled scouring pads.
• Rub in direction of the grain line
to avoid marring the surface.
• Always wipe dry to avoid water
marks.
• KitchenAid
Formula Stainless Steel Cleaner
& Polish is the cleaner
recommended for cleaning
stainless steel surfaces on this
product. To order call our
Customer Service Center at

Wiring diagram

:
® Professional
1-800-442-9991 or order on-line at
www.applianceaccessories.com
and ask for part number
8171420. To order from Canada,
call 1-800-807-6777.
• If commercial cleaners are used,
follow label directions. Do not
use products that contain
chlorine (bleach). Chlorine is a
corrosive substance.
For routine cleaning and
fingerprints, use liquid detergent
soap and water, or all-purpose
cleaner. Wipe with damp cloth or
sponge, then rinse with clean
water and wipe dry.
Accessories
available from your dealer
Replacement Charcoal Filter:
Part No. 8285507.
For use with Non-vented
(recirculating) Kit No's. 8285505
and 8285506 only.