Removing The Shells; Nstalling The Floor - European Touch Rinato SPA Service Manual

To install the shells on your spa follow the instructions below:
Step 1
Step 3
All Rinato Spas installed with gravity drain and / or hard piped to hot and cold supply lines MUST be anchored to the
floor.
Note: Moving spa with flexible hose connected may cause strain and cause leaks.
Step 1
Check your state and local regulations for cleaning procedures. Links to your state boards can be found on our web site,
at www.europeantouch.com. Refer to the Owner's Manual for "Clean Touch™ Pipe-Free
Disinfecting Procedures," for cleaning recommendations.
To remove the chrome drain handle, loosen the
set screw in the slot on the drain handle and slip
off chrome handle from chrome handle post.
Document ID: 30080002
R
EMOVING THE
Step 2
I

NSTALLING THE FLOOR

Steps 2 & 3
R
EMOVING AND
Rev: C
S
HELLS
1. Remove the front plate from the front of the
spa.
2. Remove each thumb screw (total 2)
3. Slightly lift side panels (total 2) off of the spa
to remove.
M
OUNTING
1. Adjust the leveling feet until you have at
least a ¼" gap between the frame and
leveling foot.
2. Place the floor mounting brackets on to
leveling feet diagonally from each other (2
brackets provided).
3. Mark spots to be drilled. (noted by dot in
image) Bracket has ½" hole. If mounting
to floor, use (2) 3/8" floor lag bolts with
washer (not provided).
R D
EPLACING RAIN
Drain handle removed
Technical Support: 800-626-6912
B
RACKETS
K
NOB
®
Spa - Cleaning and
Drain plunger removed
Page 7 of 16