Interlogix AL1191 Installation Instructions

Smart Card Reader AL1191, AL-1193
Installation Instructions
Introduction
This is the Smart Card Reader Installation Instructions for
models AL-1191 and AL-1193. The smart card reader is a
multifunction, all-purpose proximity card reader suitable for all
locations (including outdoors) that require a short-range
reader. You can connect the reader directly to the Alliance
system RS485 databus.
You can configure the reader through the control panel menu
when it is connected to the system databus, through the DGP
menu when it is connected to the local databus, or you can use
a configuration card. Refer to the Smart Card Reader
Programming Manual for more information.
The AL-1191 model is shipped with a white removable cover
(there are five other colors available).
Reader components
Figure 1 below shows the reader components.
Figure 1: Reader components
AL-1191
AL-1193
Blue LED. Door open, disarmed.
Red LED. Door open, armed
Comms. LED control, buzzer control, power.
Installation
You should program the reader and change the default
address (16) before you install the reader. Refer to the Smart
Card Reader Programming Manual for programming details.
You can mount the reader on any flat surface with two #6 (3 to
3.5 mm diameter) panhead screws (Figure 1). We do not
recommend using countersunk screws.
You will experience a slightly reduced range if you mount the
reader on a metal surface. If you mount the AL-1191 reader
outdoors, ensure that the blue LED is at the top.
To mount the reader, do the following:
1.
2.
Cover
3.
Blue LED
Wiring
Table 1 below describes the reader wiring components.
Red LED
Comms
Table 1: Wiring com ponents
Wire color
Red
Black
Blue LED
Green
Red LED
White
Comms
Gently pry the AL-1191 cover sides away from the main
reader body to remove cover and expose the mounting
screws. Do not use excessive force or the reader can be
irreparably damaged.
Mount the reader using the mounting screws.
Gently press the cover over the main body of the AL-1191
reader until it locks into place.
Nam e Description
Positiv e 9 to 14 VDC supply .
O V
DC supply ground.
D-/D0/Data RS485 Data -, Wiegand Data 0 Absolute
maximum, 12 V at 10 mA
D+/D1/Clock RS485 Data +, Wiegand Data 1 Absolute
maximum, 12 V at 10 mA
P/N 1040736 • REV E • OCT12