Side Windows - Mercedes-Benz C-Class Operator's Manual

C-class
Hide thumbs Also See for C-Class:
Table of Contents

Advertisement

Side windows

86
relieve you of the responsibility of paying
attention when closing a side window.
G
WARNING
The reversing feature does not react:
to soft, light and thin objects, e.g. small
R
fingers
over the last 4 mm of the closing movement
R
during resetting
R
when closing the side window again
R
manually immediately after automatic
reversing
This means that the reversing feature cannot
prevent someone being trapped in these
situations. There is a risk of injury.
Make sure that no body parts are in close
proximity during the closing procedure. If
someone becomes trapped, press the switch
to open the side window again.
Opening and closing the side
windows
Front left
:
Front right
;
Rear right
=
Rear left
?
The switches for all side windows are located
on the driver's door. There is also a switch on
each door for the corresponding side window.
The switches on the driver's door take
precedence.
i
The side windows cannot be operated
from the rear when the override feature for
the side windows is activated (
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
To open: press the corresponding switch.
X
To close: pull the corresponding switch.
X
i
If you press the switch beyond the point
of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
i
You can continue to operate the side
windows after you switch off the engine or
remove the SmartKey. This function is
available for up to five minutes or until the
driver's or front-passenger door is opened.
Convenience opening
You can ventilate the vehicle before you start
driving. To do this, the SmartKey is used to
carry out the following functions
simultaneously:
unlock the vehicle
R
open the side windows
R
open the sliding sunroof or the panorama
R
roof with power tilt/sliding panel and the
roller sunblinds
i
The convenience opening feature can
only be operated using the SmartKey. The
SmartKey must be close to the driver's
door handle.
Point the tip of the SmartKey at the driver's
X
door handle.
Press and hold the % button until the
X
side windows and the sliding sunroof or the
panorama roof with power tilt/sliding
panel are in the desired position.
If the roller sunblinds of the panorama roof
with power tilt/sliding panel are closed, the
roller sunblinds are opened first.
page 63).
Y

Advertisement

Table of Contents
loading

Table of Contents