MTD 3-in-1 Battery Mower Operator's Manual page 9

3. Place the upper handle onto the lower handle, keeping the
motor cord over the handles. See Fig. 3-3.
Figure 3-3
a. For the lowest setting, line up the top holes of the
upper handle with the holes on the lower handle.
b. For the medium setting, line up the middle holes
of the upper handle with the holes on the lower
handle.
c. For the highest setting, line up the bottom holes
of the upper handle with the holes on the lower
handle.
4. Insert toggle clamps packed separately with the mower
into the holes for the selected height. See Fig. 3-3.
5. Tighten the clamps by pivoting them upward. See Fig. 3-4.
NOTE: When tightening, leave some space between the
toggle clamp and the handle. If clamp will not tighten,
loosen the toggle clamp one turn. If clamp is not firmly
seated when engaged, tighten the toggle clamp one turn.
Figure 3-4
Cord Guide
Make sure the cord between the motor/blade control lever
and the mower sits in the cord holders on the upper and lower
handles.
1. Snap one cord guide onto the lower handle and the other
cord guide onto the upper handle. See Fig. 3-5.
Figure 3-5
2. Secure the motor cord in the cord guide clamps.
S
ection
3 — A & S -U
SSembly et p
9