Table of Contents
Advertisement
Quick Links
IM10139
JUMP STARTER
September, 2013
11912
For use with machines having Code Numbers:
Safety Depends on You
Century charging and jump start-
ing equipment is designed and
built with safety in mind.
However, your overall safety can
be increased by proper installa-
tion ... and thoughtful operation
on your part. DO NOT INSTALL,
OPERATE OR REPAIR THIS
EQUIPMENT WITHOUT READ-
ING THIS MANUAL AND THE
SAFETY PRECAUTIONS CON-
TAINED THROUGHOUT. And,
most importantly, think before
you act and be careful.
BC
OPERATORʼS MANUAL
Century Equipment
2345 Murphy Blvd. Gainesville, GA 30504
Advertisement
Table of Contents
Summary of Contents for Century K3236-1
- Page 1 JUMP STARTER September, 2013 11912 For use with machines having Code Numbers: Safety Depends on You Century charging and jump start- ing equipment is designed and built with safety in mind. However, your overall safety can be increased by proper installa- tion ...
-
Page 2: Safety Information
SAFETY Congratulations on the purchase of your new battery charg- 11. ALWAYS plug in and unplug the ac power cord by er. We wish to acknowledge Underwriters Laboratories grasping the power cord plug, NOT THE POWER CORD, (U/L) for contributing the following important safety precau- to reduce risk of damaging power cord. - Page 3 SAFETY FIRE HAZARDS BATTERY EXPLOSION HAZARDS 1. To reduce the risk of battery explosion, read, understand, 1. NEVER use an attachment not recommended or sold by and follow these instructions, those published by the bat- the battery charger manufacturer for use with your specif- tery manufacturer, and those of the manufacturer of any ic model charger.
-
Page 4: Table Of Contents
TABLE OF CONTENTS Page Specifications .........................Section A Technical Specifications .......................A-1 Operation.........................Section B Description ...........................B-1 Controls and Indicators ......................B-1 Operating Instructions ......................B-2 Maintenance ....................Section D Charging the Power Supply...................D-1 Battery Removal and Disposal ................D-1 FCC Statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,... -
Page 5: Specifications
SPECIFICATIONS TECHNICAL SPECIFICATIONS - Jump Starter / Portable Power Station Manual for K3236-1, (Code 11912) 1. Output Voltage: 12 Vdc 2. Battery: 12V Sealed Lead Acid (AGM). 3. Charging Circuit Automatic - Can leave plugged in when not in use. -
Page 6: Operation
OPERATION DESCRIPTION This unit has a sealed lead acid battery and should be kept fully charged at all times for maximum battery life. Recharge when first received, immediately after each use, and every three months if not used. Failure to do this may cause the battery life to be greatly reduced. -
Page 7: Operating Instructions
OPERATION OPERATING INSTRUCTIONS: Using as a Battery Charger If a vehicleʼs battery is discharged, you may plug one USING AS A JUMP STARTER end of the 12V charging cord into the 12V socket on the front of the Jump Starter, then plug the other end A. -
Page 8: Maintenance
MAINTENANCE CHARGING THE POWER SUPPLY WARNING 1. Never unplug the extension cord by pulling on 1. Using a 120V AC Wall Outlet (preferred method) Plug the female end of the cord onto the male plug the cord. Do not use the extension cord if the on the front of the power supply, then plug the cord or plug is damaged. - Page 9 NOTES JUMP STARTER...
- Page 10 NOTES JUMP STARTER...
- Page 11 NOTES JUMP STARTER...
- Page 12 Century Equipment 2345 Murphy Blvd. Gainesville, GA 30504...