Removing The Grill Cut-Off Microswitch And The "On" Microswitch; Upper Panel - Electrolux Built-in Ovens Service Manual

3.7.2. REMOVING THE GRILL CUT-OFF MICROSWITCH AND THE "ON"
MICROSWITCH (electromechanical versions only)
Before removing the grill cut-off microswitch and the "ON" microswitch, remove the knobs.
Then, remove the front control panel.
Grill cut-off microswitch:
1. Remove the faston connector for the grill cut-off microswtch (note its position).
2. Remove the screws which secure the grill cut-off microswitch in position (see fig. 58).
"ON" microswitch:
1. Remove the grill cut-off control bracket (fig. 58, pos. 7).
2. Detach the wiring from the microswitch.
3. Detach the "ON" microswitch from the gas thermostat pin (fig. 58, pos. 2).
Fig. 58
1. PILOT LAMPS
2. "ON" MICROSWITCH
3. GRILL EXCLUSION
MICROSWITCH
4. FASTON CONNECTOR
FOR GRILL EXCLUSION
MICROSWITCH
5. CONTROL LEVER FOR
GRILL EXCLUSION
MICROSWITCH
6. GAS THERMOSTAT
CONTROL SPINDLE
7. CONTROL BRACKET
FOR GRILL EXCLUSION
MICROSWITCH
3.7.3. UPPER PANEL (fan and safety thermostat)
In both types of oven (electromechanical and electronic), the tangential cooling fan can be
accessed by removing the upper panel from the oven.
Proceed as follows to remove the tangential cooling fan:
1. Remove the screws which secure the upper panel in position.
2. Detach the wires from the tangential cooling fan.
3. Remove the screws which secure the tangential cooling fan (fig. 59, pos. 9, and fig. 60,
pos. 7).
4. Remove the tangential cooling fan.
SOI 04.04 FV 33/50 599 35 96-40