Dvs Support - Akai VirtualDJ 8 Operation Manual

18. CUE MIX: Use this knob to mix between Cue and Program in the Headphone
channel. When all the way to the left, only channels routed to Cue (via the PFL
buttons) will be heard. When all the way to the right, only the Program mix will be
heard.
19. CUE GAIN. Adjusts the volume level of the headphone output.
20. MASTER VOLUME: Adjusts the Master Output Volume.
21. VU METERS. The Bar Leds will indicate the output level of the left, right and Master
Channel.
22. XFADE REV. Use this switcher to reverse the direction of the crossfader.
23. XFADE CURVE. Adjusts the slope of the crossfader curve. Turn the knob to the left
for a smooth fade (mixing) or to the right for a sharp cut (scratching). The center
position is a typical setting for club performances.
24. HEADPHONES SOCKET. Connect your 1/8" headphones to this output for cueing
and mix monitoring.
25. USB. This USB connection sends and receives audio and control information from a
connected computer. The AMX is USB powered.
26. MASTER OUTPUT: Use standard RCA cables to connect this output to a speaker or
amplifier system. The level of this output is controlled by the Master knob on the top
panel.
27. LINE INPUTS. Connect your audio sources to these inputs. Both Inputs can accept
line and phono-level signals.

DVS Support

The AMX is offering DVS (Digital Vinyl System) support with VirtualDJ 8. A timecode Plus or
Pro Infinity license is required.
Up to 2 Timecode Inputs can be assigned and control any software decks via
Timecode CDs or Vinyls. Both Mixer Channels can accept LINE (Timecode CDs) and
PHONO Sources (Timecode Vinyls) depending on the LINE/PHONO switchers at the top
panel of the unit.
Connect your Timecode devices at the rear panel of the AMX, open the AUDIO page of
VirtualDJ Config and click on the TIMECODE button of the INPUT tab. VirtualDJ will
automatically create the following Audio configuration.
VirtualDJ 8 – AKAI AMX
8