Power On/Off; Turning On The Power; Turning Off The Power - Hitachi CP-WX625 User Manual – Operating Manual

Power on/off

Contents
Power on/off

Turning on the power

Make sure that the power cord is firmly and
1.
correctly connected to the projector and the outlet.
Remove the lens cover, and set the power switch
2.
to the ON position (marked
The POWER indicator will light up in steady orange
69). Then wait several seconds because the
(
buttons may not function for these several seconds.
Press the STANDBY/ON button on the projector or
3.
the remote control.
The projection lamp will light up and the POWER indicator will begin blinking in green. When the power is
completely on, the indicator will stop blinking and light in steady green.
To display the picture, select an input signal according to the section "Selecting an input signal" (

Turning off the power

Press the STANDBY/ON button on the projector or the remote control.
1.
The message "Power off?" will appear on the screen for about 5 seconds.
Press the STANDBY/ON button on the projector or the remote control again while
2.
the message appears.
The projector lamp will go off, and the POWER indicator will begin blinking in orange.
Then the POWER indicator will stop blinking and light in steady orange when the
lamp cooling is complete.
Make sure that the POWER indicator lights in steady orange, and set the
3.
power switch to the OFF position (marked "O").
The POWER indicator will go off. Attach the lens cover.
Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector
on again too soon could shorten the lifetime of some consumable parts of the projector.
WARNING
not look into the lens of the projector or look inside of the projector through any
of the projector's openings.
►Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
NOTE • Turn the power on/off in right order. Please power on the projector prior
to the connected devices. Power off the projector later than the connected devices.
• When the AUTO ON of the OPTION Menu is set to the TURN ON, and the power
was turned off by the power switch last time, turning the power switch on makes the
projection lamp light on without pushing the STANDBY/ON button (
• Use the shutdown switch (
normal procedure.
16
I
"
►A strong light is emitted when the projector's power is on. Do
71) only when the projector is not turned off by
).
"
STANDBY/ON button
POWER indicator
LASER
INDICATOR
STANDBY/ON VIDEO RGB
MY SOURCE/
DOC.CAMERA
SEARCH
BLANK LASER
ASPECT
PUSH ENTER
PAGE UP PAGE DOWN
ESC MENU RESET
PbyP
POSITION AUTO
MAGNIFY MY BUTTON VOLUME
+
ON 1
OFF 2 -
FREEZE KEYSTONE MUTE
Power
switch
44).
17,18).