Handset Charging Cradle; Advanced Settings; Registration; Unregister The Handsets - RCA 2100 Quick Setup Manual

Handset Charging Cradle

1. Plug the AC power converter of the charging cradle into the electrical
outlet.
CAUTION: To reduce risk of personal injury, fire, or damage use only
the power adaptor (Manufacturer: ESL, Type: IA5060, 120Vac/6Vdc/
500mA) listed in the user's guide. This power adaptor is intended
to be correctly orientated in a vertical or floor mount position.
2. Place the handset in the charging cradle. The charge indicator turns on,
verifying the battery is charging.
3. Allow the phone to charge for 16 hours prior to first use. If you don't
properly charge the phone, battery performance is compromised.

Advanced settings

Registration

You can register additional handsets to the base station. The base station can
register up to 4 handsets.
1 Press MENU on the handset.
2 Select [ADVANCED SET] > [REGISTRATION], then press [OK] to confirm.
3 Press and hold on the base station for 5 seconds until you hear a
confirmation beep.
4 Enter the system PIN. Press [BACK] to make corrections.
5 Press [OK] to confirm the PIN.
»» Registration is completed in less than 2 minutes. The base automatically
assigns a handset number to the handset.
Note
•• If the PIN is incorrect or no base is found within a certain period, your
handset displays a notification message. Repeat the above procedure if
registration fails.

Unregister the handsets

1 If two handsets share the same base station, you can unregister a handset
with another handset.
2 Press MENU.
3 Select [ADVANCED SET] > [UNREGISTER], then press [OK] to confirm.
4 Select the handset number to be unregistered.
5 Press [OK] to confirm.
»» The handset is unregistered.
Tip
• The handset number displays beside the handset name in standby mode.