Listening To The Radio; Storing Manually - Sony XSP-N1BT Operating Instructions Manual

Placement of the smartphone
To remove a smartphone
Press RELEASE on the main unit.
Be careful not to allow the device to fall.
About the magnetic charging connector
A Sony Xperia smartphone with a magnetic
charging connector can be charged by placing it on
the unit. (Charging indicator on the smartphone
lights up.) If charging is not possible and the
smartphone is in a case, remove the case, and set
the smartphone on the unit again.
Magnetic charging
connector
Notes
 Place your smartphone before driving. A traffic
accident may result if you set a device while driving.
 Closing the USB cover is recommended when a
smartphone is placed on the unit.
 If a smartphone wobbles on the unit, it may fall from
the unit while driving and cause malfunction. To
prevent this, place the device properly.
 Depending on the shape of a smartphone case, the
unit may not hold the smartphone stably and
securely. In such circumstances, remove the
smartphone case.
 Be careful not to knock a smartphone, especially
under the following circumstances.
 Placing/removing a smartphone.
 Pushing down the cradle clamp to secure a
smartphone in place.
 Opening/closing the USB cover while a
smartphone is placed on the unit.
 Do not forcefully push a smartphone while it is placed
on the unit.
10
GB

Listening to the Radio

Listening to the Radio
Tuning step setting is required (page 7).
To listen to the radio, press SOURCE to select
[TUNER].
Storing automatically (BTM)
1
Press MODE to change the band (FM1,
FM2, FM3, AM1 or AM2).
2
Press and hold MENU.
3
Press / to select [GENERAL], then
press ENTER.
4
Press / to select [BTM], then press
ENTER.
The unit stores stations in order of frequency on
the number buttons.
Tuning
1
Press MODE to change the band (FM1,
FM2, FM3, AM1 or AM2).
2
Perform tuning.
To tune manually
Press and hold / to locate the approximate
frequency, then press / repeatedly to fine
adjust to the desired frequency.
To tune automatically
Press /.
Scanning stops when the unit receives a station.
Repeat this procedure until the desired station
is received.

Storing manually

1
While receiving the station that you want
to store, press and hold a number button
(1 to 6) until [MEM] appears.
Receiving the stored stations
1
Select the band, then press a number
button (1 to 6).