Electrical Requirements; Parts And Features; Turntable - KitchenAid YKBMC14 Use & Care Manual

Electrical Requirements

Observe all governing codes and ordinances. The microwave
oven is connected to a 110-volt side of the 240-volt circuit
required for the lower oven. If the incoming voltage to the
microwave oven is less than 110 volts, cooking times may be
longer. Have a qualified electrician check your electrical system.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
For a permanently connected appliance:
This appliance must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment grounding
terminal or lead on the appliance.
SAVE THESE INSTRUCTIONS
This device complies with Part 18 of the FCC Rules.

PARTS AND FEATURES

A
B
C
D
E
F
A. Lower oven control
(on some models)
B. Door safety lock system
C. Microwave oven light
D. Glass turntable
E. Metal shielded window
F. Door handle
G. Microwave oven control panel

Turntable

A
B
C
D
A. Turntable
B. Hub
C. Support
D. Shaft
The turntable rotates in both directions to help cook food more
evenly. Do not operate the microwave oven without the turntable
in place. See "Assistance or Service" to reorder any of the parts.
To Install:
1. Remove tape from the hub.
2. Place the support on the microwave oven cavity bottom.
3. Place the turntable on the support.
Fit the raised, curved lines in the center of the turntable
bottom between the three spokes of the hub. The rollers on
the support should fit inside the turntable bottom ridge.
G
H
I
J
K
H. Quartz broil element
(hidden in ceiling, near door)
I. Convection element and fan
(not visible - on some models)
J. Cooking guide label
K. Removable turntable support
Parts and Features not shown
Oven vent (behind door handle)
5