Initial Start-Up (Engine) - MULTIQUIP QP-3TZ Operation And Parts Manual

CAUTION CAUTION CAUTION
CAUTION CAUTION
DO NOT attempt to operate the pump
until the Safety, General Information and
Inspection sections of this manual have
been
understood .
This section is intended to assist the operator with the initial
start-up of the trash pump. It is extremely important that this
section be read carefully before attempting to use the pump in
the field.
Starting the Engine ( HATZ engine)
3. Move the engine speed lever to the START position
(Figure 8).
Figure 8. Engine Speed Lever (START position)
4. Grasp the starter grip (Figure 9) and slowly pull it out until
you feel the strongest resistance then return the starter grip
to the initial position.
Figure 9. Starter Grip
PAGE 18 — QP- 3TZ TRASH PUMP — OPERATION & PARTS MANUAL — REV. #0 (03/29/05)
read and thoroughly
QP-3TZ — INITIAL START-UP (ENGINE)
CAUTION CAUTION
CAUTION CAUTION CAUTION
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
5. Pull the starter grip again, hard and fast, pulling it all the
way out to start engine.
6. If the engine does not start, repeat steps 4 and 5.
CAUTI CAUTI
CAUTI CAUTION CAUTI
ALWAYS run engine at full speed while pumping.
Stopping The Engine
Normal Shutdown
1. Move the engine speed lever to the low speed and run the
engine for about three minutes with no load.
2. After the engine cools, move the engine speed lever to the
STOP position (Figure 11).
Figure 11. Engine Speed Lever (STOP Position)
4. Slowly pull the starter grip (Figure 9) until strong resistance
is felt and leave it in this position. This prevents rust from
forming while the engine is not in use.
CAUTI CAUTI
CAUTI CAUTION CAUTI
When stopping the engine, reduce the load slowly. Do
not stop engine suddenly since it may cause the
temperature to rise abnormally.
Emergency Shutdown
1. To stop engine immediately, quickly place the engine speed
lever to the STOP position.