EnGenius ECB1221R Setup Manual
Hide thumbs
Also See for ECB1221R:
- User manual (69 pages) ,
- Quick start manual (13 pages) ,
- Setup manual (8 pages)
Related Manuals for EnGenius ECB1221R
Summary of Contents for EnGenius ECB1221R
-
Page 1: Setup Guide
Unit 6, 5 Stone Street Kaiapoi, Canterbury New Zealand +64 3 741 1339 www.gowifi.co.nz EnGenius Repeater Setup Guide (ECB1221R / ESR-1221EXT) By Daniel Allin, Technician (DipCN, MTCNA) Go Wireless NZ Ltd... - Page 2 Step 1: Locate your Network Settings and note down your IP Address, Subnet Mask, and default-gateway: Step 2: Note down the wireless SSID your wish to repeat (Mine will be www.gowifi.co.nz): Go Wireless NZ Ltd...
- Page 3 Open your network connections and disable the wireless connection: Step 5: Depending on the EnGenius Router Model you have you may or may not need to assign a static IP address to your computer to access and configure it for the first time.
- Page 4 Step 6: Plug your EnGenius Router into your computer and power it on. (It takes about 30sec to boot). Connect to the EnGenius Router (Open Internet Explorer and type 192.168.1.1 into the address bar): ESR-1221 EXT: Skip to Step 8, your router is already in AP Mode!
- Page 5 Step 8: Go to the Wireless basics page put your Wireless SSID that you recorded in step 2 (You will need to make sure you select the same channel that your main Wireless AP is on: Step 9: Enter your Wireless Security details recorded in Step 3: (yourpasskeyhere = your current Wireless Password you use to connect to your Wireless Network) Go Wireless NZ Ltd...
- Page 6 Check that the EnGenius Router is connected and repeating: Under the Wireless Repeater Interface Configuration (above) you should see the State as Connected. This means The EnGenius router is now connected to your main Wireless Router and Repeating! Once finished, open your network connections again and set your “Local Area Connection”...