Samsung DV455 Series User Manual page 37

Connecting to the network using the WPS setting
• Samsung dryersv use PBC as the WPS type. Check if the current wired/wireless sharer
• Check if the wired/wireless sharer has a WPS button.
1. Press and hold both the Temp. and Start/Pause buttons
for 3 seconds.
2. Turn the Cycle Selector until "UP" is displayed on the
display panel and press the Start/Pause button.
3. Press and hold the WPS button of the wired/wireless
sharer that will be connected with the dryer for 120
seconds or less to run the WPS function of the wired/
wireless sharer. If the WPS function runs, the wired/wireless
sharer automatically fetches the necessary information from
the dryer and the dryer is automatically connected to the
Internet through the wired/wireless sharer.
CAUTION
4. If the dryer and the wired/wireless sharer are properly
connected, the
30 seconds.
5. Press and hold the Signal On/Off button for 3 seconds
to fi nish the Smart Control connection setup. When the
setup is completed normally, the
display panel with a beeping sound.
Connecting to the network using the Samsung Laundry App
1. Press and hold both the Temp. and Start/Pause buttons
for 3 seconds.
2. If "AP" is displayed on the display panel, press the
Start/Pause button.
If the connection is not established within 5 minutes,
"FAP" is displayed on the display panel.
DV455-02836F_EN.indd Sec3:37 DV455-02836F_EN.indd Sec3:37
supports Wi-Fi Protected Setup™(WPS).
If the connection is not established within 5 minutes,
"FUP" is displayed on the display panel.
• How to use the WPS function of the wired/wireless sharer may diff er depending
on the manufacturer. Refer to the user manual of the corresponding wired/wireless
sharer.
• Even after the WPS setup is complete, it may take some time until the actual
connection is established to allocate an IP address through DHCP (up to 5 minutes).
• Note that if you use a wired/wireless sharer that is not WPS-certifi ed, the dryer
may not be connected through Wi-Fi or a device that was connected to the wired/
wireless sharer may be disconnected.
• Please note that for some wired/wireless sharers, if you press and hold the WPS
button for some time, the settings of the sharer may be reset.
indicator blinks on the display panel for
If you press and hold the Signal On/Off button for 3
seconds when the dryer and the wired/wireless sharer
are not properly connected, the invalid button sound
is heard and the Smart Control connection setup is
not completed.
indicator blinks on the
Operating instructions, tips _37
2012-03-21 2012-03-21 1:25:03 1:25:03