Test and Measurement
This is a basic test
setup for measuring the output voltages of the inverter circuit. The
output voltage to th
e tube can be measured with a dual-channel oscilloscope and two
lo
w-capacitance (< 2.5 pf) scope probes. The oscilloscope should be connected
differentially, with the probe grounds connected and floating as depicted in the diagram
Figure 7 indicates how an oscilloscope can be used for achieving these measurement
Channel A should be added to the inverse
waveform on the oscilloscope.
Output waveform
This is what the typical output current waveform should look like as viewed in the above
test arrangement.
Figure 34
of channel B to produce the complete
Figure 35
48
.
s.