Installing The Heater - Toyotomi zibro RS – 24 Operating Manual

manUal
A

INSTALLINg THE HEATER

1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
 a manual fuel pump
 a transportation cap
 these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2 Remove the other packaging materials:
 Remove the packaging material from the grill . Lift the grill from the slot
(Fig. B) and pull it forward.
 Push the packing material on top of the combustion chamber  slightly
down and remove it (Fig. C). Remove the packaging materials from under
the combustion chamber as well (Fig. D).
 Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle  (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
 Open the lid of the removable tank  and remove the piece of cardboard.
3 Fill the removable tank as indicated in Section B.
4 Insert the batteries into their holder  at the back of the heater (Fig. F).
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing.
5 The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not correct the situation by placing books or other goods
under the heater.
6 Your heater is now ready for use.
A
4
5