Installation; Connecting To Power - Samsung SOC-4030 Instruction Manual

Installation

Connecting to a Monitor
Please connect the video output terminal located on the back of the camera to the
monitor.
CCD Camera
• The connection method varies depending on the type of monitor and accessories.
Please refer to the user's manual for each instrument.
• Please turn off the power when connecting.
• Please select Hi-Z on the 75Ω/Hi-Z switch for the intermediate video TV set and
select 75Ω for the Intermediate device as shown in the picture below.
CCD Camera
COLOR CCD CAMERA 14
Monitor
Intermediate End monitor
User's Manual

Connecting to Power

• Use AC 24V/300mA or DC 12V/500mA power source for SOC-4030N/SOC-4030P.
Resistance of copper wire [at 20C˚ (68˚F)]
Copper wire size(AWG) #24(0.22mm 2 ) #22(0.33mm
Resistance value(Ω/m) 0.078
Voltage drop(V/m) 0.028
• As the voltage drop according to the length of the cable in the above table,
a camera may malfunction if there is an excessively long cable run.
* Voltage for camera operation: 12V DC ±10%
* Voltage drops in the above table are variable according to types of cable manufacturer.
Notes
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
COLOR CCD CAMERA
2 ) #20(0.52mm 2 ) #18(0.83mm 2 )
0.050 0.030 0.018
0.018 0.011 0.006
15 User's Manual