Rear View Connections - Sceptre X32 User Manual

SCEPTRE X32 HDTV User Manual

Rear View Connections

The following descriptions are for connections from left to right.
SERVICE – This port is for factory service by Sceptre's technicians only.
LINE OUT - This connection port is used for sending out audio signals to other
audio devices such as stereo/surround sound receivers and sending out video
signals to other video device such as TV monitor or VCR. The red (R) and white
(L) connectors sends out the audio signal. The yellow (AV OUT) connector
sends out the video signal. The orange (COAXIAL SPDIF OUT) connector
sends out either bit-stream or PCM digital sound signal to a home theater
receiver with digital input. This connection uses RCA audio cable for sound,
composite cable for video, and a coaxial cable for digital out. Please note : You
can only use the red/white connection or the orange one. Do NOT connect both.
HDMI – Connects to devices that use HDMI cable, such as Blu-ray or HD DVD
player, or HD cable / satellite set-top box. This connection port receives pure
digital audio and high definition signal through one single cable. This port also
can accept a HDCP video device for video.
VGA - This connection port connects to a PC for video using VGA cable. Be sure
to connect your audio cable to the VGA Stereo input if you want sound out of
VGA video source.
VGA STEREO INPUT - This connection port is for people who want to provide
audio to the TV when using a PC or a DVI video device. The sources uses
3.5mm mini-jack audio cable to provides audio for a HDCP enabled DVI video
device or PCs with VGA connection.
COMPONENT 1 & 2 (YPbPr with Audi L/R) – These connection ports are for
DVD players, or satellite / cable set-top boxes that use component cables. From
left to right, connect green, blue, and red for video, and then connect white for left
channel audio, and red for right channel audio.
- 14 -
www.SCEPTRE.com