Input Resolution - Panasonic Viera TC-P50GT30 Owner's Manual

Settings
• Some menus are grayed out depending on the input signal or condition.
(e.g. "Zoom adjustments" will be grayed out if the aspect is not set to Zoom.)
Aspect
adjustments
PC adjustments
HDMI settings
50
Items Item Description
Screen format FULL/H-FILL/
JUST/4:3/ZOOM
HD size Size 1/Size 2
H size Size 1/Size 2
Zoom
Adjusts vertical alignment and size when aspect setting is "ZOOM".
adjustments
Reset to defaults Resets PC adjustments.
Sync H & V
On green
Dot clock Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is blurred.
H-position Adjusts the horizontal position.
V-position Adjusts the vertical position.
Clock phase Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the clock Phase
so that a clear picture appears.
●
It may not be possible to display a clear picture due to poor input signals.
Input Switches to wide display.
●
VGA (640×480 pixels), WVGA (852×480 pixels), XGA (1,024×768 pixels),
resolution
WXGA (1,280×768 pixels)
●
Options change depending on signals
H-frequency Displays the H (Horizontal)/V (Vertical) frequencies.
Display range
V-frequency
Horizontal: 15 - 110 kHz
Vertical:
HDMI/DVI RGB Auto/
range (HDMI 1-4) Standard
(16-235)/
Nonstandard
Contents type Off/Auto/Photo/
(HDMI 1-4) Graphics
Changes the format (aspect ratio).
Lets you choose the aspect depending on the format of
received signal. (p. 55)
Selects between 95 % (Size 1) or 100 % (Size 2) for the
scanning area with High-definition signal.
Select "Size 1" if noise is generated on the edges of the screen.
●
Size 1: Selected item for "HD size". Scanning 95 %
●
Size 2: Selected item for "HD size". Scanning 100 %
Adjusts the horizontal display range to reduce noise of both side
edges of an image.
Size 2: Adjusts the image size according to the aspect mode to
reduce noise. (p. 55)
The H and V sync signals are input from the HD/VD connector. (p. 58)
Uses a synchronized signal on the Video G signal, which is
input from the G connector. (p. 58)
48 - 120 Hz
Prevents the blown out highlights and blocked up shadows when
a wide-range signal is received. Selects between standard RGB
range (16-235 bits) or non-compliance (0-255 bits).
Auto: Switches the RGB range (Standard (16-235)/
Nonstandard) depending on the HDMI signal information.
Sets content type to each HDMI input.
Auto: Switches content type automatically depending on the
HDMI signal information.
Photo: Best setting for JPEG viewing.
Graphics: Best setting for On-Screen display of connected
equipment.