Cautions On Loading Discs; Cautions On Handling; Cautions On Storing Discs; Cleaning Discs - Denon DCM-27 Operating Instructions Manual

Cd auto changer
Hide thumbs Also See for DCM-27:
Table of Contents

Advertisement

ENGLISH
Getting Started

Cautions on loading discs

• Only load one disc per tray at a time. Loading two or more discs per
tray can damage the set or scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
• Do not use discs on which the sticky part of cellophane tape or
labels is exposed or on which there are traces of where labels have
been removed. Such discs could get caught inside the player and
damage it.

Cautions on handling

• Do not get fingerprints, oil or dirt on discs.
• Take special care not to scratch discs when removing them from
their cases.
• Do not bend or heat discs.
• Do not enlarge the hole at the center.
• Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly from
a cold place (outdoors for example) to a warm place, but do not try
to dry them off using a hairdryer, etc.

Cautions on storing discs

• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from dust,
scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of time
2. Dusty or humid places
3. Places exposed to heat from heating appliances, etc.

Cleaning discs

• If there are fingerprints or dirt on discs, wipe them off before using
the disc. If not the sound quality could be reduced and the sound
may be broken.
• Use a commercially available disc cleaning set or a soft cloth to clean
discs.
Do not wipe with a circular motion.
Gently wipe the disc from the
inside towards the outside.
NOTE:
• Do not use record spray, antistatic agents, or benzene, thinner or
other solvents.

About the remote control unit

Inserting the batteries

q Remove the remote control
w Set two R03/AAA batteries in
unit's rear cover.
the battery compartment in
the indicated direction.
e Put the rear cover back on.
3
ENGLISH
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated nearby the unit.
(The attached batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the "<" and ">" marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries
in flames.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote if it will not be in use for
long periods.

Operating range of the remote control unit

• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of up to about
8 meters, at a horizontal angle of up to 30° with respect to the
sensor.
30°
30°
Approx. 8 m
NOTE:
• It may be difficult to operate the remote control unit if the remote
sensor is exposed to direct sunlight or strong artificial light.
Getting Started

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcm-290Dcm-390

Table of Contents