Table of Contents
Advertisement
5. Connect one end of the USB cable to the USB upstream terminal on the back of the
monitor, and connect the other end of the USB cable to an appropriate USB port on your
computer. In Monitor Mode, user is able to control the camera and touch features through
the notebook when it's connected by Micro USB port (USB 3.0). This is applicable for
systems of Windows 7 and Windows 8.
Note:
The USB port will stay in function as long as the monitor is connected to power,
regardless of whether the monitor is switched on or off.
6. Insert the DC output connector from the external power supply into the power connector
of the monitor and connect the power cord into the external power adapter.
Plug the power cord from the monitor external power supply and the power cord from the
system into grounded electrical outlets.
Note:
A certified power supply cord has to be used with this equipment. The relevant
national installation and or equipment regulations shall be considered. A certified power
supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC
60227 (designation H05VV-F 3G 0.75mm
Alternative a flexible cord be of synthetic rubber according to IEC 60245 (designation
H05RR-F 3G 0.75c) shall be used. Only the power cord supplied with your ThinkVision
28 should be used.
2
or H05VVH2-F2 3G 0.75mm
2
) shall be used.
1-6
Chapter 1.
Advertisement
Table of Contents
