Table of Contents
Advertisement
Quick Links
INSTALLATION / WIRE
CONNECTION GUIDE
Before Starting
1. This set is exclusively for use in cars with a negative ground
12 V power supply.
2. Read these instructions carefully.
3.
sure to disconnect the battery "-" terminal before starting.
Be
This is to prevent short circuits during installation. (Figure 1)
Package Contents
Main unit ................................................... 1
Wiring harness .......................................... 1
GPS antenna ............................................ 1
Clamp for GPS antenna's cable ............... 3
Double face tape for GPS Antenna .......... 1
Remote control unit .................................. 1
Battery (CR2025) ...................................... 1
(Installed in remote control)
Trim ring ................................................... 1
Cleaning cloth........................................... 1
Warranty Card .......................................... 1
Owner's manual (CD-R) ........................... 1
Quick Start Guide and
Installation manual.....................................1
Electro tap ................................................ 2
Mounting Bracket key ............................. 2
Flush mount bolts .................................... 4
Hexagon Head Screw .............................. 5
AV cable
................................................... 1
Rear radio stud and stopper ....................1
Car battery
Figure 1
NZ502E
29
Advertisement
Table of Contents
Related Manuals for Clarion NZ502E
Summary of Contents for Clarion NZ502E
-
Page 1: Package Contents
Mounting Bracket key ......2 Battery (CR2025) ........1 Flush mount bolts ........4 Hexagon Head Screw ......5 (Installed in remote control) AV cable ........... 1 Trim ring ........... 1 Rear radio stud and stopper ....1 Cleaning cloth........... 1 NZ502E... -
Page 2: General Cautions
For installation, consult your dealer or an authorized tough dirt, apply a little cold or warm water to a soft Clarion service center. cloth and wipe off the dirt gently. Cautions on Installation 1. - Page 3 Universal Mount Note: • Some car models require special mounting kits for 1. Place the universal mounting bracket into the proper installation. Consult your Clarion dealer for instrument panel, use a screwdriver to bend details. each stopper of the universal mounting •...
- Page 4 *2 The screws with this mark are enclosed in this set. *3 In some cases, the center panel may require some modification (trimming, filling, etc.). *4 If the hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or a similar tool. NZ502E...
-
Page 5: Cautions On Wiring
There are various types of fuse holder. Do not let the battery side touch other metal parts. CAUTION After the connection, fix the cord by a clamp or insulation tape for protection. Fuse (15A FUSE) Fuse holder Figure 8 NZ502E... - Page 6 GPS antenna minimized. • Wire the GPS antenna cord. Fasten the cord using the cord holders. Cord holder Double-sided tape • Stick the double-sided tape to the bottom face of the GPS antenna. Bottom face of the GPS antenna NZ502E...
-
Page 7: Wire Connections
Line Out Rear L Line Out Gray Front R White Line Out Front L Yellow Monitor Video Out Black Yellow Camera Rear Vision Camera White Rear zone out L Green Rear zone out R Gray Steering Wheel Remote Control Terminal NZ502E... - Page 8 For VW and Audi: Change wiring as above +12V accessory Note: *1: Connecting the PHONE INTERRUPT terminal The phone interrupt will mute the audio if the lead receives a negative or ground signal. See next page for how to connect the parking brake cord. NZ502E...
-
Page 9: Connecting The Accessories
• The iPod/ iPhone connection will charge your iPod/iPhone unless the iPod/iPhone battery is completely depleted. If the specified cord of the cellular phone is connected to the phone interrupt cord of the main unit, the audio mute is activated when cellular phone in use. NZ502E...