Setting Up The Computer; Install - Sharp LCD MONITOR Operation Manual

Install

Caution
• To install, an administrator name (user name) and password are required.
• If an older version of the touch display driver 2 is installed, remove (uninstall) the old version before installing the touch
display driver 2. (See page 12.)
• Do not touch the touch panel when connecting the USB cable.
If you touch the touch panel, it will lead to a malfunction. In this case, disconnect and then reconnect the USB cable.
1. Start your computer.
2. Exit all applications that are running.
3. Connect the USB cable for the touch panel to the computer.
4. Run the setup program.
(1) Double-click the "TouchDisplay" folder, and then double-click the "Mac" folder.
(2) Double-click "SharpTouchDisplay2.pkg".
5. Click "Continue".
Follow the on-screen instructions to install the driver.
• If a screen prompting you to enter the name and password appears, enter the name and password of the administrator
and click "Install Software" (or "OK").
• If the "When this software finishes installing, you must restart your computer. Are you sure you want to install the software
now?" screen appears, click "Continue Installation".
6. When the installation finished screen appears, click "Restart".
This completes the installation of the touch display driver 2.
Each time the computer is started, the touch display driver 2 will start automatically to enable the touch panel to be used.
4
E

Setting up the Computer

USB cable (Supplied)
Touch Panel port
To the USB terminal
of the PC