Advertisement
Voltage/Wattage
ELECTRICAL CONNECTION
-
Before plugging in the heater, check that the voltage of your domestic supply corresponds to the voltage (V) indicated on the
appliance.
-
Before using the appliance check that your supply voltage is the same of that shown on the rating label of the unit.
-
THIS APPLIANCE CONFORMS TO DIRECTIVE 89/336/CEE GOVERNING RADIO INTERFERENCE, RELATING TO
ELECTROMAGNETIC COMPATIBILITY.
INSTALLATION
The appliance can be used on any horizontal support surface.
It can also be wall-mounted, proceeding as follows:
Drill the holes in the wall, heeding the minimum distances indicated in Fig. 2.
Hang the appliance on the wall and fasten it using the third screw at the bottom.
Installations in bathrooms must be performed by qualified persons, in compliance with the standards in force;
The appliance must be installed outside of the prescribed protective volume (Fig. 3) and in any case away from bathtubs, showers,
washbasins, taps, etc.
The appliance must not be positioned directly underneath a fixed power point.
OPERATION AND USE
Foot switch
This appliance is supplied with a foot switch.
After having set the thermostat and the functions as described below (fig.1) , simply press the foot switch to start the appliance.
To switch it off, simply press the foot switch again.
IMPORTANT
The appliance can only be started when the pedal switch is activated
Models with function selector and ambient thermostat
-
Turn the thermostat dial fully clockwise to the maximum position
-
Summer use: (ventilation only): turn the dial to position
-
Reduced power heating: turn the dial (left) to position 1.
-
Full power heating: turn the dial (left) to position 2.
-
Switching off: turn the dial (left) to position 0.
Models with switch and/or ambient thermostat (if fitted)
-
Turn the thermostat dial fully clockwise to the maximum position
-
Reduced power heating: press the "
-
Full power heating: press both switches (the red area is visible on the switch)
-
Summer use (ventilation only): turn the thermostat dial (right) fully clockwise to the maximum position, with the two switches in the off
position.
-
Switching the appliance off: turn off the switches and turn the thermostat dial anti-clockwise to the minimum position.
The power plug should always be removed when the appliance is not in use.
SETTING THE THERMOSTAT
When the room has reached the desired temperature, slowly turn the right thermostat dial (if fitted) clockwise, until the appliance switches
off. The thermostat will automatically control and maintain the set temperature constant.
ANTIFREEZE FUNCTION
To switch on the appliace press the foot switch, place the left dial in position 2, or move the switches so that the red area appears, and then
place the right thermostat dial in position
The appliance will maintain a minimum room temperature of approximately 5°C thus preventing freezing with a minimum energy
consumption.
FLOW DIRECTION
THE APPLIANCE CAN BE ADJUSTED AND INCLINED MANUALLY SO AS TO AIM THE FLOW OF AIR IN THE DESIRED DIRECTION
MAINTENANCE
-
Always pull the plug out of the power point before cleaning the heater.
-
Periodically clean the air intake and outlet grilles during the period in which the heater is in use.
-
Do not use abrasive cleaning products or solvents.
" switch (the red area is visible on the switch)
.
See rating label
Advertisement
