This manual will guide you through the assembly process. If at any time you are having trouble with the assembly or use of this product, then please contact us at our Keys Fitness Helpline. We have trained service technicians on site to take care of you, our valued customer.
• This Power System unit should only be used on a level surface and is intended for indoor use only. Keys Fitness recommends an equipment mat be placed under the unit to protect the floor or carpet and for easier cleaning.
Page 4
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 1 Attach Middle Base (2) to Left Rear Upright (4) and Inner Base (1) using Bolts (42), Washers (53) and Nylon Lock Nuts (54).
Page 5
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 2 Attach Middle Base (2) to Right Rear Upright (3) and Inner Base (1) using Bolts (42), Washers (53) and Nylon Lock Nuts (54).
Page 6
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 3 NOTE: Before completing any other steps, you should position each side of the unit where it will stay once fully assembled such that the total length is 12 feet long. This will keep you from having to move the unit once it is loaded with weights.
Page 7
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 4 Slide Left Slide Frame (6) onto Slide Guide Tube (5) as shown and lock into one of the holes in tube. Attach Slide Guide Tube (5) to Inner Base (1) with Bolt (41), Washers (53) and Nylon Lock Nut (54).
Page 8
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 5 Slide Right Slide Frame (7) onto Slide Guide Tube (5) as shown and lock into one of the holes in tube. Attach Slide Guide Tube (5) to Inner Base (1) with Bolt (41), Washers (53) and Nylon Lock Nut (54).
Page 9
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 6 Slide Top Cross Tube (11) into both sides of the Top Frame (8) and secure as shown. Note: two people will be needed to complete this step safely. Connect Chin-Up Handle (16) to Top Cross Tube (11) using Bolts (48), Washers (53) and Nylon Lock Nuts (54).
Page 10
ASSEMBLY NOTE: Hand tighten bolts and nylon nuts until STEP 8. STEP 7 Insert Cable (15) and pulleys and secure as shown. NOTE: The weight stack is not shown for better viewing of cable instructions.
Page 11
ASSEMBLY STEP 8 Attach Handle (10) to each side of frame and secure with Bolts (39) and Washers (51). TIGHTEN ALL BOLTS AND NUTS before continuing! Once all bolts and nuts are tightened, then attach Weight Shrouds (12) with Allen Bolts (49) and Washers (52).
DESCRIPTION inner base middle base right rear upright left rear upright slide guide tube left slide frame right slide frame top frame guide rod handle top cross tube weight shroud double pulley block swivel pulley block cable chin-up handle selector rod jam nut pop pin 4.5"...
Page 14
Product. To obtain warranty service, you must contact a Keys authorized retailer, service technician or Keys Fitness at our phone number located in this manual. Any parts determined to be defective must be returned to Keys to obtain warranty service. You must prepay any shipping charges, export taxes, custom duties and taxes, or any other charges associated with transportation of the parts or Product.
Page 16
Keys Fitness Products, L.P. 4009 Distribution Drive, Suite 250 Garland, Texas 75041 Customer Service: 1-800-683-1236...