Table Of Contents - Pioneer S-VW02 Operating Instructions Manual

LINE VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on the
rear panel. Check that it is set properly before
plugging the power cord into the outlet. If the
voltage is not properly set or if you move to an
area where the voltage requirements differ, adjust
the selector switch as follows:
¶ Be sure to disconnect the power cord from its
outlet before making this adjustment.
¶ Use a medium-sized (flat blade) screwdriver.
Insert the tip of the screwdriver into the groove
of the selector switch and turn it so that the
power voltage marking of your area points to
the arrow.
240V
220-
230V
110-
127V
CAUTION 220 - 230 V
Power source voltage is factory adjusted
220 - 230 volts. If your area is different,
change voltage selectors settings.
WARNING:
BEFORE PLUGGING IN THE UNIT
FOR THE FIRST TIME, READ THE FOLLOWING
SECTION CAREFULLY. THE VOLTAGE OF THE
AVAILABLE POWER SUPPLY DIFFERS
ACCORDING TO COUNTRY OR REGION. BE SURE
THAT THE POWER SUPPLY VOLTAGE OF THE
AREA WHERE THIS UNIT WILL BE USED MEETS
THE REQUIRED VOLTAGE (E.G., 230V OR 120V)
WRITTEN ON THE REAR PANEL.
CONTENTS
FEATURES ................................. 4
ACCESSORY ITEMS .................. 4
BEFORE USE.............................. 4
CABINET MAINTENANCE ......... 4
INSTALLATION.......................... 5
Speaker Installation ................... 5
Installation Precautions ............. 5
IN COMBINATION WITH
SPEAKERS ................................. 6
LINE LEVEL CONNECTION ....... 6
PANEL FACILITIES..................... 7
OPERATION ............................... 8
TROUBLESHOOTING ................ 8
SPECIFICATIONS....................... 9
H038 En
H041A_En
3
En