Operation; Specifications - Napa 6-1012 Instruction Manual

OPERATION

Always place a chisel in the hammer
and hold the tool down to the
work before operating. Damage to
the tool or the retainer may result
if this precaution is not followed.
The chisel retainers are not
designed for complete safety
against accidental release of cutters
or hammers. To avoid injury, the
throttle must never be depressed
unless the chisel is held firmly
4 PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
against the work place. When tool
is not in actual use, the chisel must
be removed. During operation,
safety goggles should always be
used to guard against flying rust
and chips. When using tool,
regulate the speed so that the
chisel is not being driven out of
the cylinder. If piston is allowed to
strike the cylinder wall, internal
damage will result.
Air Regulator
To change chisel, pull back on the
retainer and insert chisel. Release
retainer.
To regulate air, turn air regulator
knob out for maximum air pressure
and in for minimum.
S
PECIFICATIONS
Blows Per Minute ........2,200 BPM min.
Bore Diameter ................................3/4"
Piston Stroke................................3-3/4"
Air Inlet Thread ......................1/4" NPT
Hose Size ..................................3/8" I.D.
Avg. Air Consumption..................4 cfm
Rec. Air Pressure ..........90 psig (6.2bar)
Air Inlet
Sound Level..............................110 dBA
Length ........................................10.63"
Shipping Weight ....................5.66 Lbs.
Rev. 5/29/02