Kenmore 721. 62622 Service Manual page 17

B. REMOVING THE OUT CASE(Figure 8)
(1) Remove the vent grille by removing two screws
securing it to the out case.
(2) Remove two screws securing it to the front
bracket.
(3) Remove two screws securing it to the air duct.
(4) Remove the mounting plate by turning the two
screws securing it to the out case.
(5) Remove the base plate by removing four screws
securing it to the out case. Remove the Mount,
All from the out case by removing two screws
securing it to the out case.
(6) Remove four screws from the rear section.
(7) Remove the outcase with pushing it back.
Door
Vent Grille
Mount, All
Controller
Figure 8
7-6
Power code
Mounting
Plate
Out Case