Table of Contents
Advertisement
5. Connecting Front Panel cable
Attach the power LED, speaker, and reset switch connectors to the corresponding
pins. If you enable "Suspend Mode" item in BIOS Setup, the ACPI & Power LED
will keep flashing while the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is 2-pin female
connector from the housing front panel. Plug this connector to the soft-power
switch connector marked SPWR.
6. Connecting ATX Power Cables
This motherboard comes with a 24-pin and 4-pin ATX power connector as shown
below. Make sure you plug in the right direction. We strongly recommend you to
insert the 4-pin connector before connecting the 24-pin connector.
1
Power Switch
NC
NC
GND
Power LED-
+5V
HDD LED
GND
Power LED+
HDD LED
NC
+5V
+5V
GND
GND
GND
NC
RESET
SPEAKER
GND
Front Panel Connector
+12V
+12V
Ground
Ground
7. Power-on and Loading BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power
on and enter the BIOS Setup, press <Del> during POST (Power On Self
Del
Test). Choose "Load Optimized Defaults" for recommended optimal
performance.
8. AOpen EzInstall and Bonus Pack CD
You can use the autorun menu of Bonus CD disc. Choose the utility and driver
from the icons at left side, and then click on the "GO" button to complete
installation automatically.
Install driver
Install utility
Browse
Read me
Exit CD
Click to install
online manual
Hide quick links:
Advertisement
Table of Contents
