Ice Maker Tips - Silhouette Veneto DPC042D1BSSPR Owner's Use And Care Manual

Operating Instructions
CONNECTING ICE MAKER TO WATER SUPPLY (continued)
10. To turn the ice maker on, lower wire signal alarm (see Ice Maker front cover for ON/OFF position of arm). It takes
approximately 2 hours for the ice maker to begin producing ice. New plumbing may cause ice to be discoloured or
have a poor fl avour. Discard ice made during the fi rst 2 batches.
REMEMBER: Water quality determines your ice quality. Do not connect the ice maker to water that is softened, chemicals
from the softener can damage the ice maker.
If your model has an adjustable freezer shelf, place the shelf so that the wire signal arm of the ice maker will hit the
ice when the ice container is full. To stop the ice maker, lift the wire signal arm until it clicks and locks in the "up" or "off"
position. This ice maker turns off automatically when the ice container is full and stops arm from moving.

ICE MAKER TIPS

1. Ice stored for too long may develop an odd fl avour. Empty the container and be sure the wire signal arm is in its
"down" or "on" position. The ice maker will then produce more ice.
2. Occasionally shake the container to keep the ice separated.
3. Keep the wire signal arm in its "up" or "off" position until the party center is connected to the water supply of whenever
the water is turned off.
4. Certain sounds are normal when the ice maker is operating, such as:
• Motor operation
• Ice being loosened from the tray
• Ice being dropped into the container
• Running water
• Water valve opening and closing.
5. Stop the ice maker when cleaning the freezer, or for short vacations.
6. If the ice maker will be turned off for a long period of time, turn the water supply valve to the closed postion.
STOCKING INSTRUCTIONS
Upper left wine compartment:
In order to achieve the maximum storage capacity of twelve (12) 750mL wine bottles, it
will be necessary to position the bottles alternately on the three (3) racks as shown in fi g.
E. This will allow for the storage of four (4) bottles per rach in each of the top three (3)
racks, for a total of twelve (12) wine bottles.
Right beverage compartment:
In order to achieve the maximum storage capacity of sixty (60) 355mL beverage cans;
place eighteen (18) cans on each of the top three (3) shelves and six (6) cans on the
botton shelf. Fill the top shelves with three (3) rows of six (6) cans standing upright. The
bottom shelf holds six (6) cans when the cans are laid down (horizontally) in three (3)
rows, each row two (2) cans deep.
Wire
Signal Arm
Ice Maker
8
Fig. E