Pride Go-Chair Owner's Manual page 33

V I I . C A R E A N D M A I N T E N A N C E
8. Reconnect the two (2) battery leads to the battery terminals. Make sure the red lead is connected to the (+) positive
terminal and the black lead is connected to the (-) negative terminal.
9. Replace the lid and carefully flip the battery box over so the handle is down.
10. Replace and tighten all the screws that hold the battery box together.
11. Reinstall the battery box back onto the Go-Chair.
When to See An Authorized Pride Provider for Service
The following symptoms could indicate a serious problem with your Go-Chair. If necessary, contact an authorized Pride
Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.
! Motor noise
! Frayed harnesses
! Cracked or broken connectors
! Uneven wear on any of the tires
! Jerky motion
! Pulling to one side
! Bent or broken wheel assemblies
! Does not power up
! Powers up, but does not move
Corrective Maintenance
If the battery condition meter does not light up when you turn on the power:
! Check the harness connections. Make sure they are tight.
! Check the circuit breaker. Reset it if necessary.
! Check the battery connections.
If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available
at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load
tester. If either one of the batteries fails the load test, replace both of them. If your Go-Chair still does not power up,
contact an authorized Pride Provider.
Go-Chair www.pridemobility.com 33