Kenwood VR-4090 Connect And Set Up page 50

Chapter Three: Setting Up on the Receiver
2. Adjusting the speaker volumes
Adjust the volume balance between the speakers in the sys-
tem by actually listening to them. See page 37 for details.
1 Minimize external noise in the listening room.
2 Position yourself in a place where you usually listen
to music or view video.
3 Increase the receiver's main volume to "-25 dB". (To
improve the adjustment accuracy, it is effective to set
the volumes at a slightly loud volume.)
4 Perform operation in step - of procedure 1 on pre-
vious page. The speaker volume adjustment display
appears and test noise is generated from the front
left speaker ("L 0 dB" displayed). Listen to the vol-
ume of the noise carefully.
5 When the test noise moves to the center speaker and
"C 0 dB" is displayed, adjust the volume to the same
44
level as the front left speaker by pressing the MULTI
CONTROL (fi/%) key.
6 Similarly, adjust the volumes from the "R" (front
right), "RS" (right surround) and "LS" (left surround)
speakers.
7 Press the SET UP key to proceed to "Selecting the
speaker distances" below. To exit from setting, press
the SET UP key repeatedly until "SETUP FIXED" is
displayed.
Do not adjust the "SW" (Sub Woofer) volume using
the test noise. It should be adjusted while listening
to ordinary music.
3. Selecting the speaker distances
Measure the distance between each speaker and the listen-
ing position you frequently use. See page 38 for details.
1 After the operation of 7 in procedure 2, the speaker
distance setting display appears.
2 When "L 3.0m/10ft" is displayed, correct the dis-
tance of the front left speaker from you using the
MULTI CONTROL (fi/%) key.
3 Press SET UP key to display "C
correct the distance of the center speaker from you
using the MULTI CONTROL (fi/%) key.
4 Similarly, set the distances of the "R" (front right),
"RS" (right surround), "LS" (left surround) and "SW"
(Sub Woofer) speakers.
5 Press the SET UP key repeatedly until "SETUP FIXED"
is displayed.
3.0m/10ft" and