PSC PT 2000 User Manual page 121

Keyboard
Wedge
Configuration
Figure D-3: Back of the PT Dock
User's Guide
To configure the keyboard wedge, complete the following steps:
1.
Turn off the power to the workstation.
2.
Plug the 25-pin connector of the cable into the cable input jack
on the back of the PT Dock (refer to
Power input jack
3.
Attach the small male plug of the PSC cable to the keyboard jack
on the workstation (refer to
4.
Attach the keyboard cable to the small female jack on the PSC
cable (refer to
5.
Turn the workstation on. The green light-emitting diode (LED)
labeled
POWER
up.
Cable input jack
Figure D-4 on page 112
Figure D-4 on page 112
on the front panel of the PT Dock should light
Setting Up the Dock
).
Figure D-3
).
).
111