Differential Signals; Sas-3 Specification Compliance; Additional Information - Seagate ST6000NM0014 Product Manual

Enterprise capacity 3.5 hdd v4 sas
Hide thumbs Also See for ST6000NM0014:
Table of Contents

Advertisement

Table 17 LED drive signal
State
LED off, high
LED on, low

11.5.2 Differential signals

The drive SAS differential signals comply with the intra-enclosure (internal connector) requirements of the SAS standard.
Table 18 defines the general interface characteristics.
Table 18 General interface characteristics
Characteristic
Bit rate (nominal)
Unit interval (UI)(nominal)
Impedance (nominal, differential )
Transmitter transients, maximum
Receiver transients, maximum
11.6

SAS-3 Specification Compliance

Seagate SAS-3 compatible drives are compliant with the latest SAS-3 Specification (T10/BSR INCITS 519 rev. 06).
The main difference from SAS-2 is the Tx and Rx training that allows the host and drive to adjust the amplitude and emphasis values to the
channel. The receiver still employs Decision Feedback Equalizer (DFE) and Feed Forward Equalizer (FFE) circuitry to accomplish this
training.
1. A Decision Feedback Equalizer (DFE) which utilizes the standard SAS-2 training pattern transmitted during the SNW-3
training gap. The DFE circuit can derive an optimal equalization characteristic to compensate for many of the receive
losses in the system.
2. A Feed Forward Equalizer (FFE) optimized to provide balanced receive margins over a range of channels bounded by
the best and worst case channels as defined by the relevant ANSI standard.
11.7

Additional information

Please contact the Seagate representative for SAS electrical details, if required.
For more information about the Phy, Link, Transport, and Applications layers of the SAS interface, refer to the Seagate SAS Interface
Manual, part number 100293071.
For more information about the SCSI commands used by Seagate SAS drives, refer to the Seagate SCSI Commands Reference Manual,
part number 100293068.
Seagate Enterprise Capacity 3.5 HDD v4 SAS Product Manual, Rev. B
Test condition
0 V
VOH
3.6 V
I
= 15 mA
OL
Units
Mbaud
ps
ohm
V
V
Output voltage
-100 μA < I
< 100 μA
OH
0
V
0.225 V
OL
1.5Gb/s
3.0Gb/s
1,500
3,000
666.6
333.3
100
100
± 1.2
± 1.2
± 1.2
± 1.2
6.0Gb/s
12 Gbps
6,000
12000
166.6
83.3
100
100
± 1.2
± 1.2
± 1.2
± 1.2
66

Advertisement

Table of Contents
loading

Table of Contents