Samsung SHS-1321 Instruction Manual

Instruction
Manual
Convenient Opening of the
Door
Simple operation via card and
passcode
Dual-Authentication
Feature
Dual-Authentication feature through
card and passcode
Prank Prevention Feature
In the case of entering unregistered
information, the attempt is
automatically blocked
Dual-Lock Feature
With dual-lock feature, the security
is enhanced
Fire Detection Feature
Built-in fire detection sensor
Crime Prevention Feature
When going out, crime prevention
feature can be used.
Internet Home Page
SamsungSNS(Inc.)
Anywhere in the country If you accurately provide the product name,
ServiceCenter
fault condition, and contact number, then
Representative
we will always provide kind assistance and
PhoneNumber quick service to customers' questions.
GC68-01769A ED:03
Opening the door from the outside
(passcode)
When the product is first purchased, it is set in dual-security
mode. To set the product into normal mode, please refer to
the 'dual-security mode setting" method.
1. Press the [Number Input] button
[Number Keypad] is touched.
2. Enter the passcode.
Dual-security mode
Two buttons randomly lit When all of the lights in
up, so press the two the number keypad show
numbers in the up, enter the passcode
sequence. and press [*] button.
Normal Mode
Success :
↑Ding Dong Deng Dong Melody
Fail :
When all of the lights in the number keypad show
up, enter the passcode and press [*] button.
Passcode must be entered when the number keypad is lighted up,
so if the lights are not on, then touch the [number keypad] and then
re-enter the passcode.
When the passcode is incorrectly entered to cancel the input, press
Reference
the [ ] button and start from the beginning.
If the passcode is incorrectly entered for five consecutive sounds, a
different alarm sound is played for about 10 seconds, and the
operation of doorlock is paused for roughly 3 minutes. During the
operation pause status, "beep" sound is played every 10 seconds,
and after 3 minutes, a long "beep" sound is played, and the pause
status is automatically disabled.
Precautions for Safety
Precautions for safety protect the user's safety and prevent damages
and inconvenience due to accidents. Please read this and use the
product properly.
Warning
Do not install or repair the product
randomly as you want.
Do not install the product in a location
where the gap between the door and
doorframe is more than 5mm.
Cautiously manage the passcode so
that other people cannot know it, and
regularly change the number.
Do not operate the product when your
hand is wet, and be careful to not let
water, beverages, and other liquid to
get inside the product.
Do not forcibly press or use a sharp
tool to hit the button.
When you are going out, always
check the ensure that the door was
fully locked.
Product Components
Product components may be changed depending on the
installation environment.
Outside
of Main Unit
Warning
You must carry or keep at least one
emergency key outside.
In the case of an emergency, please
read and learn the instruction for
manual switchgear.
Opening the door from the outside
(card, key tag)
Touch the
[number pad]
Opening and closing the door from the inside
Success :
↑Ding Dong
Deng Dong
Electrically opening
Fail :
Ding Dong
the door
Ding Dong
Dual-lock
(3 seconds)
With the door locked,
pressing the [OPEN]
button of the main unit on
the inside opens the door.
Ding Dong Ding Dong Melody
Mechanically opening
the door
With the door locked, turn
the manual switchgear to
direction.
4
Properly fit the battery into the product
onto its accurate (+/-) terminals.
When the battery is incorrectly placed
in its direction or charge as displayed
into the battery room, leakage and
breakage may occur, so please be
careful.
When the battery life is ended, replace
all the batteries at once, and avoid
using new and used batteries at the
same time.
When cleaning the product, do not
wipe it with water, benzene, or
alcohol, and instead, use a dry cloth.
Replace the batteries to new ones
within one week of first hearing the
battery replacement notification alarm.
Inside of Main Unit
Doorframe Strike Plate (Strike)
Key-Tag (4EA)
'AA' Battery (LR6) (4EA)
Spacer
Instruction Manual
Installation Screw
Installation Paper Diagram
Fixed Panel
Success :
↑Ding Dong
Deng Dong
Fail :
Ding Dong
CARD
Ding Dong
When the number pad is lighted
up, contact the card or key tag in
the [card recognition area]. After
1 seconds, the door is opened.
Electrically closing
the door
Dual-lock
↑Ding Dong ↓Ding Dong
Deng Dong Deng Dong
(3 seconds)
Melody Melody
With the door manually
locked, pressing the
[OPEN] button of the main
unit on the inside locks the
already closed door.
Mechanically closing
the door
With the door closed in
manual lock status, turn
the manual switchgear to
direction.
Names and Features (Outside)
Number Keypad On
Number Keypad
Turned Off
Press the Number
Input button
Names and Features (Intside)
Opening the cover of the main unit on the inside
Gently press the battery cover of the main unit on the
inside and pull the cover in the direction shown in the
arrow.
2
※ All registration and setting up can only
be operative while the door is open.
Passcode Registration
Passcode can be registered in 4~12 digits, and only one
can be registered to use.
1. Press the [Register] button. 2. Register the new passcode.
Ding Dong Melody
Open the battery cover and Enter the new passcode (4~12
shortly press [register] button. digits) and press the [*] button.
To prevent theft accidents, it is recommended to use the passcode that
is 6 digits or longer (only 0~9 numbers are usable).
Please be careful to manage the passcode so that other people will not
Caution
know. Using the same passcode for a long period of time may lead to
its exposure, so regularly change the passcode for use.
Registered passcode cannot be deleted, so register a new passcode to
use.
Card and Key Tag Registration
When card or key tag is registered, previously registered
card and key tag information are all deleted, so try to
register all cards and key tags at once. Total of 20 card keys
and key tags can be registered (ISO 14443 Type A support)
1. Press the [Register] button. 2. Register the new passcode.
Ding Dong Melody
Open the battery cover and Contact the card or key tag that
shortly press [register] button. needs to be registered.
3. End card key registration
Ding Dong Deng Melody
To end registration, press the [register] button of the main
unit on the inside.
To register various cards and key tags continuously, register the card or
key tag, and contact another card or key tag within 10 seconds. If
another card or key tag is not registered within 10 seconds, the
Caution registration automatically ends.
To check if the card or key tag is normally registered, check the card and
key tag, and then close the door.
"Samsung SNS Doorlock" abides to the "ISO 14443 Type A standards, and
the cards, key tags, and NFC-use smartphones that completed
certification from "Samsung SNS Doorlock" are able to be registered on
the doorlock for use.
5
Number Keypad
Card Recognition
Area
External Power
Contact Area
External Power\
Contact Area
Registration Button
OPEN Button
Manual Switchgear
Deadbolt
Door Opening Sensor
Automatic/Manual Lock
Conversion Switch
3
Ding Dong Deng Melody
Ding Dong Deng
Melody
6