Kenwood NX-820H Service Manual page 55

Item Panel test mode
7.High RSSI at 1) Adj item:
-80dBm adjust [HRSS]
Adjust:[]]
2) Adj item:
[H.RSS]
[H.R.SS]
[H.R.S.S]
[H.R.S.S.]
[H.R.S.S._.]
SSG output :
-80dBm(22.4uV)
(MOD:1kHz/±1.5kHz)
This adjustment can
8. Squelch(Tight)
[Analog Narrow] be performed only
PC test mode.
[Analog Wide]
ADJUSTMENT
Measurement
PC test mode
Test-
equipment
1) Adj item: [High SSG
RSSI (Analog
Narrow)]
2) Adj item: [Low],
[Low'], [Cen-
ter], [High'],
[High] SSG
output: –80dBm
(22.4µV)
(MOD: 1kHz/±1.5kHz)
1) Adj item: [Tight SSG
Squelch (Analog
Narrow)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
Press [Apply All]
button to store
the adjustment
value.
1) Adj item: [Tight
Squelch (Analog
Wide)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
Press [Apply All]
button to store
the adjustment
value.
NX-820H(G)/820H
Unit Terminal Unit Parts
ANT
Ext.SP con-
nector
ANT [PC test
Ext.SP
mode]
connector
[ ],[
Adjustment
Specifi cations/
Method
[Panel tuning Note:
mode] Wide, very narrow
After input signal (NVDN) values are
from SSG, press same value as nar-
[<B] key to store row.
the adjustment
value.
[PC test mode]
After input signal
from SSG, press
[Apply] button to
store the adjust-
ment value.
Write the value as
Followings UHF F1/
F2.
]
・Analog Narrow
[S.QLT] → 248
[S.Q.LT] → 248
[S.Q.L.T] → 248
[S.Q.L.T.] → 248
[S.Q.L.T._.] → 248
・Analog Wide
[S.QLT] → 255
[S.Q.LT] → 255
[S.Q.L.T] → 255
[S.Q.L.T.] → 255
[S.Q.L.T._.] → 255
Remarks
55