Fisher-Price Smart Cycle Racer T3857 Owner's Manual page 3

Assembly
CAUTION
This product contains
small parts in its
unassembled state. Adult
assembly is required.
Pedal
Assembly
Frame
1
• Fit the pedal assembly into the groove in
the underside of the frame, as shown.
Hint: The pedal assembly is designed to
only fi t one way. If it does not seem to fi t,
turn it around and try again.
• Insert four screws into the pedal assembly.
Fully tighten the screws.
4
Front Base
(Small)
2
• Fit the front base (small) onto the bottom
of the frame, as shown.
Hint: The front base is designed to fi t onto
the frame one way. If it does not seem to fi t,
turn it around and try again.
• Insert four screws into the front base
and tighten.
Seat Post
Rear Base
(Large)
3
• Fit the rear base (large) onto the end of the
seat post, as shown.
Hint: The rear base is designed to fi t onto
the seat post one way. If it does not seem to
fi t, turn it around and try again.
• Insert two screws into the rear base
and tighten.
Assembly
4
• Turn both the frame and seat post
assemblies upright.
• Fit the seat post assembly onto the
frame assembly.
• Insert two screws into the seat post
and tighten.
Hint: You may want to insert the frame
cover with bolt into the frame assembly
before inserting and tightening screws in
the post.
Frame Cover
(with Bolt)
5
• Insert the frame cover with bolt into the
hole on the side of the frame assembly.
• Fully tighten the bolt.
5
Handlebar
6
• Fit the handlebar onto the frame,
as shown.
Hint: The handlebar will only fi t one way
onto the console. If it does not seem to fi t,
turn it around and try again!
• Insert two screws into the handlebar
and tighten.
• Pull up on the handlebar to be sure it
is secure.