Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Symbol MG+486
Summary of Contents for Symbol MG+486
- Page 2 Symbol reserves the right to make changes to any product to improve reliability, function, or design. Symbol does not assume any product liability arising out of, or in connection with, the application or use of any product, circuit, or application described herein.
-
Page 3: Input/Output Ports
The Mobile Gateway Plus 486 (MG+ 486) is a small, rugged computer used as a platform for in-vehicle communications and connectivity by Symbol portable data terminals. It provides wireless network communications and RS-232 flexibility. The MG+ 486 supports MS-DOS, GS-DOS and Pharlap RTOS operating environments using industry standard protocols. - Page 4 M G + 4 8 6 COM2 COM2 is an RS-232 DTE serial port using a 9-pin female DSUB connector. 12/24VDC This connector provides the input power for the MG+ 486. The MG+ 486 operates from 12 or 24 V (9V to 32V) sources. Options Several of the following options are also available: COM3 - Additional RS-232 DTE serial port.
-
Page 5: Led Indicators
Q u i c k R e f e r e n c e GPS Antenna - SMB-style connector which provides an inter- face to an external GPS antenna. S24 Antenna - Reverse BNC style connector which provides an interface to external S24 radio antenna. LED Indicators The MG+ 486 has 8 LED indicators on the front panel providing status to the user. -
Page 6: Reset Switch
M G + 4 8 6 Description USER Application-specific, can be programmed by the user. FAULT LED stays on if MG+ 486 does not boot properly. Can be programmed by the user. Reset Switch This is a momentary switch located on the front panel, to the right of the LEDs. -
Page 7: Pcmcia Interface
Q u i c k R e f e r e n c e PC104 Interface The MG+ 486 accommodates one PC104 16/8 bit card. PCMCIA Interface The MG+ 486 accommodates up to two 5V PCMCIA cards (if both slots are used, a type 3 card may be installed in the top slot only). The interface supports hot plug-in. - Page 8 M G + 4 8 6 Note: Locate the fuse as close as possible to the battery power source. 6. Connect the Vehicle Accessory Power to the vehicle accessory bus, splicing a fuseholder with a 1 amp fuse in-line with the accessory power source.
-
Page 9: Warranty
It shall not apply to any product (i) which has been repaired or altered unless done or approved by Symbol, (ii) which has not been maintained in accordance with any operating or handling instructions supplied by Symbol, (iii) which has been... - Page 10 Customer will pay for the replacement product in case it does not return the replaced product to Symbol within 3 days of receipt of the replacement product. The process for return and customer’s charges will be in accordance with Symbol’s Exchange Policy in effect at the time of the exchange.
-
Page 11: Regulatory Information
Q u i c k R e f e r e n c e Regulatory Information Radio Frequency Interference Requirements This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the Federal Communications Commissions Rules and Regulation. - Page 12 • EN 60 950 + A1+A2+A3+A4+A11 - Safety of Information Technology Equip- ment Including Electrical Business Equipment • EN 60 825-1 (EN 60 825) - Safety of Devices Containing Lasers 72-40689-01 Revision A — January 2000 Symbol Technologies, Inc. One Symbol Plaza Holtsville, NY 11742-1300...