Chevrolet 2015 Express Owner's Manual page 133

5-40 Instruments and Controls
NO CHANGE: No change will be
made to this feature. The current
setting will remain.
To select a setting, press
the desired setting is displayed on
the DIC.
REMOTE DOOR LOCK
This feature allows you to select the
type of feedback you will receive
when locking the vehicle with the
Remote Keyless Entry (RKE)
transmitter. You will not receive
feedback when locking the vehicle
with the RKE transmitter if the doors
are open. See Remote Keyless
Entry (RKE) System Operation on
page 2-2.
Press until REMOTE DOOR
LOCK appears on the DIC display.
Press once to access the settings
for this feature. Then press
scroll through the following settings:
OFF: There will be no feedback
when you press on the RKE
transmitter.
LIGHTS ONLY: The exterior lamps
will flash when you press
RKE transmitter.
while
HORN ONLY: The horn will sound
on the second press of
RKE transmitter.
HORN & LIGHTS (default): The
exterior lamps will flash when you
press on the RKE transmitter, and
the horn will sound when
pressed again within five seconds of
the previous command.
NO CHANGE: No change will be
made to this feature. The current
setting will remain.
To select a setting, press
the desired setting is displayed on
the DIC.
REMOTE DOOR UNLOCK
to
This feature allows you to select the
type of feedback you will receive
when unlocking the vehicle with the
Remote Keyless Entry (RKE)
transmitter. You will not receive
feedback when unlocking the
vehicle with the RKE transmitter if
on the
the doors are open. See Remote
Keyless Entry (RKE) System
Operation on page 2-2.
on the
Press until REMOTE DOOR
UNLOCK appears on the DIC
display. Press
the settings for this feature. Then
press to scroll through the
is
following settings:
LIGHTS OFF: The exterior lamps
will not flash when you press
the RKE transmitter.
LIGHTS ON (default): The exterior
lamps will flash when you press
while
on the RKE transmitter.
NO CHANGE: No change will be
made to this feature. The current
setting will remain.
To select a setting, press
the desired setting is displayed on
the DIC.
once to access
on
while