Bostitch H-3071 Instructions Manual page 9

COIL NAILERS
OPERATING ISSUE
Skipping fasteners;
intermittent feed
Fasteners jam in tool/canister
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 9 OF 18
TROUBLESHOOTING CONTINUED
CAUSE
Feed piston dry
Feed piston O-rings cracked/worn
Check pawl binding
Canister bottom not set correctly
Broken weld wires in nail coil
Wrong size fasteners for tool
Broken welded wires in nail coil
Wrong slide plate adjustment for
wire collated nail coil
1-800-295-5510
uline.com
CORRECTION
Add BOSTITCH Air Tool Lubricant in hole in
feed piston cover
Replace O-rings/check bumper and spring.
Lubricate assembly
Inspect pawl and spring on door
Must work freely
Set canister bottom for length of nails
being used
Remove coil of nails and use another coil
Use only recommended fasteners/check
canister bottom adjustment
Remove coil of nails and use another coil
Adjust switch pins for wire collated nail coil
0514 IH-3071