Volvo 2006 XC70 Owner's Manual page 201

NOTE - Canadian residents:
During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the
HomeLink® button. At the same time, repeatedly press and hold your
hand-held transmitter's button at two-second intervals until HomeLink®
has learned your transmitter's code. The HomeLink® indicator light
will flash first slowly, and then rapidly to indicate that the button has
been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a
rolling code system and is manufactured after 1996:
•
•
•
To train a rolling code garage door opener, follow these instructions
after programming the desired transceiver button according to "Program-
ming the transceiver." The help of a second person may make training
easier.
third time
HomeLink® Universal Transceiver (option)
garage door opener motor head unit
second
The remaining two HomeLink® buttons can be programmed in the
same way. In the event of any problems in programming the
HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used
in place of your hand-held transmitters.
To operate, the key must be turned to the "accessory" position (II) or
the engine must be running. Press the programmed HomeLink® button
to activate the garage door, driveway gate, security lighting, home
security system, etc.
Your original hand-held transmitters may, of course, be used at any
time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed
buttons:
The HomeLink® buttons can be reprogrammed using the procedures
described on the previous page.
193