Toshiba MV20FL4C Service Manual page 12

2-6: LINK UNIT (Refer to Fig. 2-6)
1. Set the Link Unit to the Eject position.
2. Remove the (A) side of the Link Unit first, then remove
the (B) side.
Link Unit
(A)
Main Chassis
2-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7)
1. Remove the Link Lever.
Remove the screw 1.
2.
3. Remove the Loading Motor Ass'y.
Unlock the 2 supports 2 and remove the Deck PCB
4.
(BOT).
Main Chassis
• Screw Torque: 5 ± 0.5kgf•cm
2-8: SENSOR COVER L3 (Refer to Fig. 2-8)
Unlock the support 1 and remove the Sensor Cover L3.
1.
Main Chassis
DISASSEMBLY INSTRUCTIONS
(B)
Link Unit
Main Chassis
Fig. 2-6
Loading Motor Ass'y
2
1
Deck PCB
(BOT)
Link Lever
Fig. 2-7
Sensor Cover L3
1
Fig. 2-8
2-9: TENSION ASS'Y (Refer to Fig. 2-9-B)
1. Turn the Middle Gear clockwise so that the Tension
Holder hook is set to the position of Fig. 2-9-A to move
the Tension Arm Ass'y.
2. Remove the Tension Spring.
Unlock the support 1 and remove the Tension Arm
3.
Ass'y.
4. Remove the Tension Adjust.
Unlock the 2 supports 2 and remove the Tension Band
5.
Ass'y.
Float the hook 3 and turn it clockwise then remove the
6.
Tension Holder.
7. Remove the SS Brake Spring.
8. Remove the SS Arm Brake.
Tension Arm Ass'y
Tension Spring
SS Brake Spring
SS Arm Brake
NOTE
When you install the Tension Adjust, install as shown in
Fig. 2-9-C. (Refer to Fig. 2-9-C)
B2-2
Tension Adjust
2
2
Tension Band Ass'y
Tension Arm Ass'y
1
Tension Holder
3
Inclined S Ass'y
Adjust the direction of the Marker to inside.
Fig. 2-9-A
Fig. 2-9-B
Fig. 2-9-C