Connecting Wires To Terminals - Kenwood KDC-W241 Instruction Manual

Connecting Wires to Terminals

Fuse (10A)
Wiring harness
(Accessory1)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Rear preput/ Subwoofer preput
(KDC-W3041/KDC-W312 only)
FM/AM antenna input
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
See next page.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Antenna Cord (JASO)
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
MUTE
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
P.CONT
antenna control terminal in the vehicle.
ANT.CONT
15
|
English