Breville vcf011 Instruction Booklet page 13

Problem
Cappuccino may
continue to dispense
for a few seconds
after the control dial
has been moved to
the STOP position.
Milk drips from the
pipe after the control
dial has been turned
to the STOP position.
Steam escapes from
the water tank cap.
The ready indicator
keeps coming on
and going off.
Coffee granules are
sticking to the inside
of the funnel
• Cause/solution
A small amount of cappuccino will continue to be dispensed as
the machine finishes its cycle. Please make allowances for this
when filling your cup.
This is the residual milk left in the pipe that has not been drawn
into the machine when the STOP was selected.
Make sure that the water tank cap is fully tightened.
The machine is fitted with a thermostat to maintain the
temperature. It is perfectly normal for the light to go on and off
whilst the machine is in use.
This can occasionally happen if excess steam is present.
Remove the funnel and wash. Allow to dry fully before using
again.
Please note that a small amount of steam may rise up the
funnel after the cycle is complete. This is perfectly normal.
13