Connecting Wires To Terminals - Kenwood KDC-MP443U Instruction Manual

Connecting Wires to Terminals

USB connector
AUX input (Stereo)
Use the mini-plug cable which is stereo
type and does not have any resistance.
Front side
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
18
|
KDC-MP5043U/ KDC-MP543U/ KDC-MP443U
Fuse (10A)
To Kenwood disc changer/ External optional accessory
(KDC-MP5043U/ MP543U only)
⁄
To connect these leads, refer to the relevant instruction manuals.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
ANT.
CONT
amplifier of the film or short pole-type antenna.
Connect to the terminal that is grounded when either the telephone rings
MUTE
or during conversation.
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
Car fuse box
ACC
FM/AM antenna input
Front output
(KDC-MP5043U/ MP543U only)
Rear output/ Sub Woofer output
Ignition key switch
Car fuse box
(Main fuse)
Battery