Table of Contents
Advertisement
Installation & Service Manual
CLEANING AND SANITATION
Component Removal and
Installation Instructions for
Cleaning
Bottom Trays
1. Remove product from bottom of case.
2. Grasp and lift out each of the bottom trays
from the case interior and carefully
remove through the door openings
3. After cleaning, replace in reverse order.
NSF Product Thermometer
Remove four screws and product thermome-
ter bracket assembly from right rear location
in the case. After cleaning, replace product
thermometer bracket assembly and secure
with four screws.
Discharge Air Honeycomb
1. Remove screws and bottom retainer strip
from front or rear interior of case.
NOTE
Note position of the honeycomb grid
during removal so it can be reinstalled
the same way.
2. Remove honeycomb grid sections from
the front or rear duct.
CAUTION
Improper installation of the honeycomb
grid section could result in improper air
flow and/or poor refrigeration.
3. After cleaning, replace honeycomb grid
sections as they were removed and
secure with the bottom retainer strip and
screws.
November, 2007
NFNX, NCNX, NFNGX,
Rear Air Duct Panels
1. Remove bottom trays and discharge air
honeycomb, see this page.
2. Remove mounting screws from rear duct
panel.
3. After cleaning, replace in reverse order.
Front Air Duct Panels
1. Remove bottom trays, see this page.
2. Remove screws and front air duct panels
from case.
3. After cleaning, replace in reverse order.
Corner Trim
1. See page 14 for corner trim removal
instructions.
2. After cleaning trim and cladding compo-
nents, replace front cladding and corner
trim components in reverse order using
instructions below and on page 14.
Front Cladding
1. Remove kickplates and raceway covers
from front of case.
2. Remove screws from bottom and top of
front cladding and pull cladding down to
remove it from behind the bottom edge of
the bumper retainer.
3. After cleaning, replace front rear cladding
and remaining components in reverse
order.
NCNGX
Page 13
Advertisement
Table of Contents
